Aopos AS260 Uživatelský manuál stáhnout pdf (Strana 21)

Programming instruction

The steps of programming are:

1. Scan the SETUP bar code on the parameter setting part.

2. Enter the option mode by scanning the Option bar code.

3. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan these

alphanumeric entries from the back foldout page.

4. Scan the END bar code, listed on the lower right hand corner of each parameter setting part.

5. Notes that only one parameter can be setup at each time.

6. During the process of programming, LED is lighting to indicate the programming correctness. LED

will go off if any incorrect programming operation performed.

7. After each successful programming, LED will go off and the scanner will beep twice.

8. Throughout the programming bar code menus, the factory default settings are indicated with

asterisks (*).

Example: to set Flow control to be XON/XOFF.

Steps: Scan the following barcodes in order.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 84 85

Žádné komentáře

Aopos AS260 Uživatelský manuál Strana 21